Try this firmware "pmcappfw3.bin" and the dji go 3.7 included in this folder. Let me know if this helps you. I been using this one for a while now and it seems really stable. Except i have not flown about 1000ft so i dont know how it acts way up there phantom-firmware-tools-master.rar
i know people that get 10kft with CE on stock config. but if you need help with the aprameters i tried to define what some of them did you can look here.
Flyc_param_infos · Issue #16 · mefistotelis/phantom-firmware-tools · GitHub
for everyone thats going high altitude "legally of course" please keep in mind that this drones restrictions were put there for more reasons than aircraft safety. when you take this thing 10,000ft in the air with that 4700 mAh battery at 10 meters per second it will use a whole lot more juice...
No height mods. You could change that if you need sorry. Also i heard that if you go 10,000 ft the drone wil land critical battery even if you have 80 percent
if anyone wants to make their drone faster here you go specs,
22.4 miles per hour ascend
17 miles per hour descend
lower idle
44 miles per hour gps
45-55 mph atti mode
this is the 2.4.2 app and the flight controller single module. to install just copy the flight controller module to the sdcard...
The fw is for the drone. Your going to want to install 1.5.8 on the rc controller, 1.7.8 on the drone. If you look at flight controller parameters on github page i have some of them sorted out so you can tune it the way you need it. And if you look at mefistotelis firmware tools you will find...
hey 1340 i got that warning on my app and it forced my to upgrade my app but not my firmware. i would suggest trying to install 1.7.6 with the debug file i bet that takes you to 1.7.6
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.