Re: phantom's Pitch/Roll is dead after upgrade kit installat
I have the same sort of problem after installing upgrade kit and 3h-2d... Doesn't come of the ground anymore. Rotating the craft stills works. Need help
f2 is empty. What should do in there? I got one black cable from the gimbal into the motherboard. This is one with 6 wires.
f2 is for a 3wire plug. Where should it come from?
Yeah I did that, the calibration.. butt nothing is happening. The red curser is all the way to the left. Nothing is responding to the controller. All the other signals work just fine.
I have the same 2 antenna model on the upgraded board. X1 and X2 it is. You can't swap them without an error in the naza pc software so there is exactly one option to put them.
Hi, i just installed the upgrade for the Phantom 1. The board upgrade. I installed the H3-2D afterwards.
When I start the Phantom without remote the H3-2D lines up and does it work.
When I start the remote the h3-2D pitches full down. I can't controle it with the mounted lever on the back of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.