Thank you @HappyStandardOwner and everyone else for the fix and updates. I bought a second-hand P3 Standard with bad RC signal and could not go further than 150 meters except with Litchi where I could go miles away while retaining video signal so that was a good alternative. Obviously i wanted a...
Normally one can feel the friction or different feel by turning the motors by hand but in my case i guess it was on the edge of being blocked intermittently.
Maybe when enough rust causing some kind of friction between stator and magnets to cause obstructed motor message which i got occasionally as well beside the ESC problem. Just a thought
You can request the firmware via DJI administrators and state model. Probably this FW has a different ESC logic to bypass a dirty coil but i still think in most cases the root cause are dirty or corroded stators. I had ESC error with often engines not starting at all and rarely 1 engine had...
I had the same in automatic mode mostly in cloudy/misty kind of weather. With ISO200 or less somehow i don’t have this noise. I’m not a photographer but this seemed to be the solution.
I had the same! Normally it’s corrosion in the electro engines not being used for a while and stored in a humid place.
I disassembled them and cleaned them with very fine sandpaper and alcohol. Also i sprayed them slightly with contactspray. Put them back together and errors where gone with...
Try reinstall current Firmware with binding button. Youtube has instruction videos. It also generates a new logfile so you might see which module is wrong.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.