Hi
I broke my zenmuse mounting bracket and bought cheap 3D printed part and got same kind of vibration. Then I ordered original part for zenmuse and it solved vibration issues. It might be plastic mounting brackets (especially down part) or loose rubber balls. First try to change stiffer rubber...
Hi
I have same kind of problems with Phantom 2.
I have not fly an inch with it.
I upgraded fimwares etc. before first light because it was suggested.
It's blinking yellow light(long not constant) Phantom 2 starts, motors reacts to TX but can't get it in the air.
I have also written to...
My Phantom 2 is also blinking "long yellows" in GPS -mode and I can't lift up.
Have you solved the problem?
GPS mode, cyros., acceler., and compass data look good?
I calibrate compass and after that it goes to this "long yellow" blink.
Have given "magnet to compass" and everything seems to...
Explain to me?
Before I started the rotors, Phantom2 did all the maneuvers which took about 15 sec. before led started to blink green it blinked couple of times fast green. Is this related to "bad imi calibration"?
Can it be reason why Phantom cannot pull up?
Hi
I'm noobie in this forum.
Just got Phantom 2 + zenmuse gimbal.
Watched all the videos and manuals before building and updating firmwares etc.
Everything seems to be OK, but can't get enough lift to raise from the ground(even without gimbal). Props are spinning, yes, they are spinning...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.