Recent content by mrself58

Currently flying F450 with NAZA lite & GPS. I am wanting to install a FPV/ OSD. I will have to upgrade the NAZA to do this. I was looking at the TBS core pro with the GPS. I can get this a lot cheaper than going all DJI. My question is will two GPS units function properly on the same quad???

Yes to all of the above. The Tx and Rx are talking to the NAZA. It does beep when powered up. The only reason I assumed the motors were not getting power is when you do the CSC nothing happens. Could it be a failsafe somewhere>

F450, brand new, bought it already assembled (my mistake) just can't seem to find the time for both. But anyway, the NAZA works the receiver has power but NO power to the motors. Normally I would check the voltage on the solder pads but there is SO much protectant you can't get a voltmeter on...

My 330 flew good until I finally hooked the GPS up. I think I did the Tx right because it shows it swapping modes and they turn blue ( so this is good??) My problem now is that since I did that when I start the motors they go very high idle for about 8 seconds and then it cuts out. I was...

My 330 flew good until I finally hooked the GPS up. I think I did the Tx right because it shows it swapping modes and they turn blue ( so this is good??) My problem now is that since I did that when I start the motors they go very high idle for about 8 seconds and then it cuts out. I was...

Thanks, one more question. What size bullet connector for the motor wires should I get to fit these port? Thanx, Mike

After my FC40 did a fly-away I thought I would try a different route. After a couple of failed EBAY deals I figured I would salvage what I could and try a DIY. Now being a newbie I am probably over my head. I have 4 motors, only markings on them is (readytoflyquads). Tried their website and...

Well I knew my GPS was not working but I HAD to fly anyway. Well I guess the wind wanted it more than me as I watchedFC40 fly off into the sunset>>>>>>>>> Glad my 450 will be here next week. If anybody has a Phantom 1.1.1 I for sale I want one, also have the Tx for my FC40 that I don't need...

yes it did land on it's top but was blinking yellow before that. Could it have cracked the GPS?

Somehow my GPS quit working. I am getting a yellow flashing light. When I hooked it up to my laptop and tried to change some things it said GPS required for this. I was told that the switch in my Tx went out. Is there any way to check the GPS first or what is my best method to try and find...

that's why I like plug-n-play

since I always run I gps mode why can't I bypass the switch. Can you do that?

Yes all swithches are in the correct position. I even cycled thru all modes.

Went to go and fly last night and when I started up my bird the light would not turn green. It blinks yellow all the time. It will fly OK BUT it will not stay stable and it lets the wind take it. Is it the GPS?? How did that happen???

Thanks guys. I knew this was the right place to get an answer