Recent content by mr-gary

Another small tidbit here, after a medium flight, with warning lights in full flash, when I land, I find that the power connector is hot. It's been hot enough to impact the heat shrink tubing on the battery. It's not too hot to touch, but close. Has anyone else experienced that?

With the props removed it ran (on a table) at 1/3 throttle for close to 10 minutes with only an occasional Low Warning blink. I shut her down with all green lights (bored).

With the stock props, battery, and no camera the quad weighs 1lb 13oz. I have some 9" CF props, but I still get the same results. And, it seems to do the same with or without the camera attached. I've also done the IMU calibration and compass calibration several times. The quad flys ok, just...

I have 3 Phantom Batteries, and they all do this (one is just 2 days old). I charge them on a stock DJI charger. After a full charge a standard volt meter shows 12.5v, and the calibrated NAZA-M V2 shows 12.5v in the Advanced > Voltage tab (X3). I’ve tried numerous variations on the 1st & 2nd...