Recent content by Moein Habibi

  1. M

    Crushed my p2 and now it gives yellow blinking.

    i dont know if the problem you are having is same as what i had. But here is what i did: 1.i changed the GPS module. 2. and also changed the receiver ( the mini chip that goes under the main board). after replacing these two my drone was good to go. Good luck!
  2. M

    Crushed my p2 and now it gives yellow blinking.

    Just giving everyone one final update: The phantom is alive and flying! 2 parts were damaged in the phantom 2, 1. the GPS module the whole thing was damaged ( not the ceramic antenna only) 2. The receiver ( the mini chip that goes under the main board) this one was damaged badly. when i...
  3. M

    Crushed my p2 and now it gives yellow blinking.

    Hi Duke, Thank you for you're respond, i do admitted, i did a terrible job fixing it. but something that caught my attention was, whenever the GPS was connected to the main board, and not inside the shell. in the DJI phantom software it was giving me ERROR [27] -- GPS not calibrated, or...
  4. M

    Crushed my p2 and now it gives yellow blinking.

    pictures of the GPS module and ceramic attena replacement
  5. M

    Crushed my p2 and now it gives yellow blinking.

    i replaced the ceramic antenna today, and when i turned on, i still got the same problem it's still blinking yellow same pattern as the video i have provided in this topic. i tried advance Calibration, reset BTU Info, and re download the firmware for the phantom 2 . and still blinking yellow...
  6. M

    Crushed my p2 and now it gives yellow blinking.

    Hey guys, sorry for taking long time to replay. to answer your questions, no is not the warm up yellow blinking, i left it on for a good 5 min and i had no green light. i took it outside as i thought it might be a gps signal lost, still was blinking the same way. so, i was searching around...
  7. M

    Crushed my p2 and now it gives yellow blinking.

    Just a side note, I opened the frame to check if anything is wrong from inside and didn't fully closed it while I was recording
  8. M

    Crushed my p2 and now it gives yellow blinking.

    Hello everyone, So yesterday, I crushed my p2 and after the crush, every time I turn it on, it gives me yellow blinks. And the motor won't turn on. I have attached a video so you guys can see the yellow pattern. Dji phantom 2 yellow flashing error: