Recent content by mntnmike

Yosemite National Park press release from today states that the use of any types of drones are prohibited within the park boundaries. The full press release can be found here: http://www.nps.gov/yose/parknews/use-of ... l-park.htm The NPS press release cites a federal park regulation that...

Re: ex CEO Colin Guinn is ALIVE, Files legal Injunction agai Doesn't look like this thread has been updated with the latest on this legal saga ... Well, this explains quite a bit: http://finance.yahoo.com/news/dji-north ... 00182.html

Re: Zenmuse tilt angles reversed? Thank you, Drew! That was it! So thankful for this community and all the support it provides! Cheers, Michael

Re: Balance Charger flashing odd sequence of lights Solved. Turns out at some point, I inserted the banana plugs reversed, and it the fuse tape burned on the negative lead on the circuit board. Found the solution here: http://www.youtube.com/watch?v=N6WWeF-_cds Easy fix with solder, but...

Re: Balance Charger flashing odd sequence of lights Does anyone know (or could check) what is the voltage coming out of the battery charger? Still trying to resolve this problem...

Re: Balance Charger flashing odd sequence of lights So I connected just the TX60 connector and the light on the charge still blinks green for ready. When I unplug the TX60 and plug in just the balance cable, the led pattern begins. So you're saying that means the solder connections in the...

Re: Balance Charger flashing odd sequence of lights Well, it's been plugged in with a battery for 9 hours now and no change in the sequence of lights. I emailed DJI but haven't heard anything back from them. Really hoping the pilots community here can help out ...

Re: Balance Charger flashing odd sequence of lights So that sequence of lights is just the balancing sequence? I'll switch the order of connection and let a battery sit on the charger today with this sequence of lights and see where it goes. Thanks Lav.

Hi everyone, I was charging my three Phantom-branded batteries on my BC20-4 Balance charger today. The first two charged no problem. When I plugged the third battery in to the charger, connecting first the red/black leads, then the 3S port, then the power cord, the LEDs started a different...

Re: Zenmuse tilt angles reversed? Help! Any ideas or solutions???

Re: Bad motor? Clicking and prop only turns one direction Solved. It wasn't a clip but a tiny screw, the size that hold the circuit board down. No idea where the screw came from as there are no screws missing. Ugh.

Hello, I've read the other posts and this problem seems different than others who are having tilt problems. I installed the Zenmuse H3-2D Gimbal with the new circuit board in the Phantom, and the little lever that comes with the board to control the tilt angle on the transmitter. I followed...

Yes, I've seen this when I first went through the manual prior to my first flight. However, the only direction that starts the motors is both down and left. None of the other combinations start the motor...

I have the same thing with my Phantom, where the sticks have to be down and to the left. I've done the calibration a couple times, and it is still the same thing. Does it matter????

I have what I suspect is a bad motor, but it started at the tail end of an easy 5 minute flight. No crash, was doing a simple hover, and started hearing a higher pitch from the Phantom. When I brought it down lower, I could hear a rapid clicking sound. Just as it landed and the props slowed...