Just recieved this from DJI -
"
Did you try to press the receiver button to rebind the TX? What was the indicator lights?
You can try to use a servo cable to connect the F1 and F2(short circuit) , then connect the phantom to PC, upgrate the firware again.
Any questions, please feel free to let...
Addendum 2:
I am also getting the error message -
CFG-ERR: Configuration error, this may cause by firmware upgrade from old version.or abnormal Tx calibration. Re-calibrate your transmitter,and power cycle your controller and check all of the parameters.
As an addendum, I have also tried to downgrade firmware using the door + Test / 125 method. It works, however you cannot use the assistant as it INSISTS you upgrade in order to use any calibration or other settings.
Firstly*** I have extensively read the manual and other posts. I have changed it to D-Bus after updating to 4.02 and importing parameters. Please save your mouse clicks and keyboard by telling me to change to D-Bus or rebind the Tx. :)
I upgraded my Phantom v1.1.1 to Firmware version 4.02 on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.