Recent content by Mircea78

Hi, you tube it. There is an example here:

Hi, as far as I know the non original rear screen are not touch screen, I don't know how good they are. Personally, I have a GoPro backpack screen for my Hero 3+ and it's ok. Found it with a discount.

Hi, what do you mean by putting "the osd on fc40"? I have a fpv flight controller N1 OSD module for DJI Naza. My version has english menu and it is very easy to setup. Features: - NAZA special OSD, no need PC parameter adjust - Support NAZA GPS, read NAZA Compass and GPS data, could direct...

Hi, I have this version: GoProStudioPC-2.5.7.549 on my win 7 32 version, but now always is asking for update, probable to change to the new version which is 64 bit version. Just send me a p.m. for details.

Hi, DJI says (Phantom FC40 - Downloads - Manuals, Software, Drivers download | DJI) : Naza-M Assistant Software v2.20 * Download the Firmware via Assistant software; the software only supports Windows XP or above (32bit/64bit). So, windows 10 should work.

Watch this one:

This is mine

Its not a disaster man. Just take care with the screws and the leads inside. And take photos while you open it, if you are not sure.

I did it in this way. I opened the shell and soldered the leads to power the gimbal. You can use also the pitch for camera, if you open the shell, for pitch control of the camera from your remote.

Multistar 4000 mAH 3s 10C. Over 13 minutes depending of flying style and conditions. Full load: gimbal 2d, tx, osd n1. I trimed a little bit the battery compartment and the door to put the leeds outside.

There are many options to power the gimbal. Watch this video, but there are a lot.

For me also p3 props works very fine. 13 min full load

You have all the downloads on DJI site. About NAZA software: read the manual. But if your quad is stock one, is fine and you dont want to upgrade it, my advice is to leave it if it works. Cheers!

Hi, try to put the settings from Mike's video: . It worked for me very well. 13 minutes. FC40, multistar 4000 lipo, full load: gimbal, gopro, tx, fpv flight controller n1 osd.

Yes. Try brushless 2 axis on ebay. There are a lot, quite good and cheap. There are also 3 axis brushless gimbal, but I didnt try and it seems they are a little bit hard to calibrate. Or you can try to find a Zenmuse 2 axis gimbal. Cheers!