is a link to video.
Also does anyone know an independent repair shop in Denver Colorado area. I tried the big shop that shows up on Google maps. They said, sorry no parts send to DJI.
This is a video after a hard landing/bounce. P3S kept flying but the gimbal started doing what you see in this video. There was no visible damage. I replaced...
I have seen the videos about the roll motor shaft position and believe it is facing in the correct direction. I will check again. It is either facing directly up or directly down. In the videos most were not straight one direction or the other. Any case I will check. I am also headed to...
Thanks. Well it did bounce and kept flying. Gamble calibration failed. I checked all the gimbals. The move freely with no binding. I check what I could see without taking apart. Is that the white plug in the picture.
Thanks, where did you get parts for fix? I tried the local DJI repair that shows up in Google Maps in Denver and they said, sorry too old of model for us to get parts.
I had a hard landing/bounce. The drone kept flying but you could see something wrong with the gimbals. I landed. No visible damage but the now the yaw gimbal goes full right to left repeated until you get a gimbal overload warning. Drone flys with no problem just video useless. I have video but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.