Recent content by mattyessex

Hi All I took my Phantom for a flight yesterday having charged all 3 batteries. Eventually after taking quite a while to get a Satellite locks I took off and after 10 seconds the battery failed and it came back down with a bump. Luckily it was only meter above ground when it just fell. All ok...

Can I ask why not the 32 channel, I have just received the 32 channel Black Pearl and use this with my AVL58 but am thinking of replacing this with the Immersion 600mW. What are the flaws with the 32 Channel Black Pearl?

Help ! I need to get an adaptor for my new antenna to attach to my AVL58. Currently they appear to have the same connector. I have been told I need a RP-SMA to SMA adaptor but having looked at a picture of the adaptors matching this on the web they look very similar to what I have currently...

I have just ordered the black pearl and ImmersionRC 5.8GHz RHCP Antenna Set SpiroNET - V2 antennas. Hopefully it will sort the issue out. I didn't really like all the bolt on bits on the FeelWorld - external battery, receiver etc.

Surely it must be better than a fuzzy rolling image when the only time it is clear is if I grab the antenna.... I can't except it will always be like this else what is the point with the concept of FPV. More to do with antennas etc.

Image is clear and stable on ground but gets worse when the Phantom moves away.

Hey, I have DJI AVL58 connected to DJI FPV Hub so no soldering required then display is Feel World but everyone says Black Pearl is much better as has built in receiver. I think I need better antennas though as picture quality not great.

Hi All After some help. Took the Phantom for first flight with GoPro and FPV setup today. All was good apart from the FPV image as it was fuzzy. If I held onto the antenna on the FeelWorld monitor it would remain stable a bit. My setup is ISOD Mini, FPV Hub, AVL58 and FeelWorld display...

I'll try formatting the card I took it straight out my dashcam. That said though it is just in standby mode.

Evening All I have setup my FPV - AVL58, ISOD mini, FPV hub. I see the isod information on the monitor but no video. Checked the GoPro and it was powered off. Turned the main power on the Phantom off and then on again and it powers the GoPro on but then after a while it the GoPro powers off...

Thanks ordered from UK

I am trying to do the same at the moment but am struggling with finding a cable long enough to reach from the FPV hub to the AVL58 - the one supplied is just to short. Any suggestions greatly received as I really want the ISOD mini, FPV hub hidden inside with only the AVL58 attached on the...

Thanks for the reply. Unfortunately not it came with the Phantom that I purchased used. I have searched high and low for an answer to see if a longer cable is available but no luck. I have read posts where people have extended the cable but above my level of expertise unfortunately. Guessing I...

Wondering if anyone is able to help. I am installing my FPV setup and would like to house it inside the Phantom apart from the AVL58. The issue I have is the cable from the FPV Hub to the AVL58 is to short. My question is do you know where I can get a longer cable from if they are...

Morning all I need to get some spare screws for the Phantom 2, noticed that a few are missing from mine. Can anyone let me know what ones are required and if spare packs are readily avaiable to buy. Checked ebay but they are listing from China. Also could do with a 2mm Hex Driver, any...