Thanks! Yes, we have turned everything off and on in the order described. The app doesn't connect to the wireless until the drone is turned on. So, turning on the RC then the Go app doesn't connect anything until the drone is turned on. Then, the phantom shows up on the phones (Samsung S6)...
I have P3A....Friend just bought P3S. First flight successful. Pulled the update today and now gets a "no signal" message on the Go App status bar.
On the P3A there is a reset hole for this issue. Can't figure it out for this craft.
Would appreciate suggestions!
THX
Just got my P3 Advanced yesterday and want to fly today. The craft's update went fine! The controller has a firmware that is 2 versions old....1.26.
I was attempting to update to 1.3.2. Using a sd card and usb reader, the update never takes on the controller.
I do have a B controller...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.