I have mounts for the flir one and will work for other flir devices in a similar orientation Phantom 3 & 4 DJI Phantom 3 & 4 FLIR One Mount - 3D Printed Drone Mods
And only if your craft is new and still under warranty you must realize the warranty is really only for DJI to hold your craft hostage for a while till it runs down and out. As a DIYer and a hobbyist, A warranty is of no use to me. Unless it's internal chip programming or something out of reach...
I un screwed all the motors, mixed up just enough for 1 motor at a time. Poured it in the motor area to just about a credit card thickness from the standoffs top. then the remainder once it thickened, used it like puddy and reinforced the arm area towards the inside where you typically see other...
They like it for convince sake because of their active lifestyles... ahhhh hahahaha, addiction and the excuse's we make because of it. (edit that out) "Bad Pop"
I suppose if your in close the vps will be of no use, however if your out at a distance and are in a hover 10-20ft off the terrain you'll very well be needing the trackimo more than stable low altitude hover.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.