My K1 on 6.0 and 7.0 has experienced lots of freezes and complete crashes. I enabled developer mode and usb debugging etc and it hasn't helped. Restarting the app was easy and I'd get video feed back to my goggles but the video feed would get very laggy. I just installed hdmi board from my P3P...
We shouldn't have to discover what Polar Pro's intentions were during design process by watching camera slam into "protective guard" :) Dan's suggestion that " you are going to want to install it post warmup" while helpful, it's not something you want to hear after the fact. You'd guess that...
No signal is for video, no connection is rc. my p3p does the same thing while flying very close in backyard but the video is still good with no breakups. Try putting unzipped bin file on fresh formatted card and that the file is correct for p3a the file naming for different models is confusing...
Usb connection on gear vr is in the way. Some guy modded his but I don't know how he did it. I bought innovator addition when they first came out $200. Don't want to risk ruining them
You can see how the goggles use suction cups to hold phone in place which isn't very secure. I had to cut a small section of plastic near side vents for better access to usb port on phone. These are super cheap goggles so don't expect comfort. I bought them to test the litchi app. You could also...
I have the gear vr but the usb is in the way so unless you want to mod and possibly ruin those goggles it's cheaper and easier to not mess with. You need a longer usb cable than the one that came with p3.
I bought some cheap ($18,00) vr goggles from Amazon and used Litchi app's VR mode. I'm using galaxy note 4. It worked pretty well specially for the money! I have the HDMI module but haven't installed it yet. I'll be getting headplay once my hobby funds accumulate again. Litchi app VR mode uses...
Yep and what happens if they say to their customers that the motor mount screws were over tightened at the factor and the user should loosen then re torque them? Every crash would be blamed on dji.
Perhaps dji isn't mentioning that something was "fixed" because that's close to admitting something was "broke" and corporations don't like to admit anything that could result in liability.
I was using dominator v1 with my p1 and still use them with p2. I haven't used them with p3 I'm ordering some cheap vr goggles that I can fit Note 4 into and use hdmi for the video feed. I have litchi app so I want to take advantage of the VR mode. Resolution on the fat sharks dominator 1 is...
I think there's a thread where someone wanted to put pro camera on advanced body but they weren't compatible if I remember correctly. I could be wrong though.
There's an issue with flying batteries that aren't fully charged. It's probably a firmware issue but we are being warned never to fly a partially charged battery.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.