Recent content by ludorhb

I use the DxO Viewpoint 2 plug-in for Aperture, and it removes the distortion using the Fisheye tool.

This has happened to me twice with iPhone 5. Once I deleted and reinstalled the app, and everything worked for a while. The second time I went to the album page, viewed a picture, the went back to the camera, and everything started working again.

It probably won't work. Vision gimbal works off 2.4GHz. The Controller is 5.8.

I'd like to see a follow me mode. The phantom could follow your cell phone using the cell phone GPS coordinates.

Just flew in foggy Colorado conditions at 6500ft altitude, temps in the mid 20 degrees F. When landing, noticed P2V was a bit shaky. After props stopped, noticed leading edges had about 1mm of ice on them. Be careful out there this winter.

I was flying two days ago. Took a call from my wife on speaker. Let the P2V hover while I talked. Hung up, everything was still connected. I also Ignored a call from my boss, and no issues there, either!

Just upgraded firmware and did a 10 min flight up to 800ft away and 150ft altitude at night in the cold. No problems.

I turned the upper of the two screws on the back of the transmitter when trying to change to FCC mode. I think I got it back to the correct position (at least close). What does this screw do, and how do I know if it is correctly set? Mike

Mine worked for a few flights, then would not connect. It showed the last image it received greyed out. I uninstalled the app, then re-installed. Everything works now. I-phone 5.