Recent content by lucid111

Wherever all other hobbyists want the setup once they see it. I'm trying to save these guys the trouble ahead of them with the "cost-effective" setup. Other people think I'm a spy lol.

I know LB is more expensive, but it's all in one solution. I suppose if you're doing this as a hobby or if this is a FPV setup for your kid, you should proceed with the items you listed. When you're ready for a high quality professional setup, buy the Lightbridge. You're going to want to get...

I was in the same boat as you were, I would rather you enjoy your setup instead of all the R&D I had to do. Let me know how it goes for you. DJI won't support you either (Since you have a 3rd party remote) as they didn't want to support me so we're on our own here - and got to help each other out.

After seeing 24 views and not one response, I'm stepping up to the task to answer your questions. Phantom 2 is a good way to go. Lightbridge is the way to go if you want a good FPV system. If you do a Mickey Mouse setup you may lose your drone. You won't need a monitor as you can use your...

From what I found, the gimble spasms are normal glitches to expect from time to time...Per the video signal, you need to update Lightbridge to the latest version as is supports more HDMI displays with last two updates. Update the firmware on both the LB Ground Station & the LB Air Unit. All you...

Just use mini HDMI to mini HDMI cable from LB to Cinemizers. Make sure you update your firmware on all LB ground and air stations.

With Lightbridge using the "HDMI Out" port on the ground station, yes you can. Keep in mind you may need HDMI repeater if you plan on using multiple displays

Sounds like you're not turning off your RF signal when you start your Futaba or your phone or GoPro camera's wifi or bluetooth is on. Make sure your phone is in airplane mode. You only need to login the app once with internet. The app may want to use GPS on your phone though.

Re: problem with dji lightbridge with t8fg after firmware up The KEY is to re-map the sticks using Lightbridge assistant, then use Phantom assistant to calibrate. Lightbridge assistant - Maps sticks, switches, buttons to LB

Good luck with that one... Just buy a P2 base model and then add Lightbridge.

You could use Lightbridge if you were planning on upgrading your controller, gimbal, and camera. 1. The controller you have does not have a Gimbal knob, therefore you will need to get a Futaba or something like it with at least 8 channels. ($500) 2. You would need a camera with HDMI out (not...

When looking into the cinemizers, how do you get rid of the blue bleeding around outside of screens?

They sell them at amazon.com and getfpv.com

The answer to your question is a straight "No". Lightbridge with the Carl Zeiss Cinemizer goggles is the best and only way to go. :ugeek:

You should get what fits your budget. Immersion with dragonlink, and Fatshark are great