Recent content by Low-Hover

Very true lka. The other BIG problem is a lot of folks associate the P3 4k Standard / 4k firmware with the Advanced / Professional firmware they are like oil and water... both are liquid but they don't mix.... fly safe...

Have the P3 4k. It is a different beast then the Advanced and Professional versions....

Cool... glad it worked!!!

Just found a thread on dji forum titled "Bricked/Manual Firmware Update" under Phantom 3 Standard/4k. I hope it helps you....

Hmm.... at this point I would call dji (you ight be on hold for 10-15 mins, but no hang ups like their old phone system) and get them to walk you through reinstalling your firmware. And if that doesn't work... get them to replace it.

Not sure if it was mandatory but.... my motors would not start nor would the icm calibrate until I downloaded the FW. Not trying to argue my point this is just my experience...

I had the exact same thing happened to me. When I connected the app it told me I needed to update. I have only had the 4k for 2 days so I don't know all of the lingo just yet but you should see update required.

Mine would not show the values until I updated the firmware.

I have a 4k and I had to update the FW

I couldn't get the motors to start until I updated the firmware. Your experience must be different from mine...

It will not take off until you update the software.