https://www.youtube.com/watch?v=qc25DdszOmQ
DJI Phantom 2 - Lightbridge with H3-3D Zenmuse gimbal + GoPro
Galaxy Tablet + Spectrum Dx7s
Taupo Motorsport Park NZ - DMNZ ( Drift Motorsport NZ ) Track Day
Conditions - We had decent wind & a little bit of rain :)
I would say its a fatal blow water and short circuiting wise to the naza, ESC.
I wouldn't trust it safety wise after going in the water, could try some rice in the naza unit to dry it out - see if that helps?
You have the gopro around the wrong way. I turned mine around the wrong way and just tested it - Mine makes the same noise.
Why?
Its because the gopro has a certain center of gravity, and centre of mass. So the gimbal is trying to balance it on that side, where more weight is.
Usually the...
yup you should be good to go with that, very similar setup to ours.
One tip which i haven't seen so far is - If you need to re-assign channels because your controller is all out - Reassign the channels via the lightbridge assistant plugged into the lightbridge ground station with your...
Reset your lightbridge ground station a few times, turn it on. Wait a good minute or so - Then boot your phantom up - wait, if it doesn't sync after a few reboots well - I hope an update or resync fixes it.
I recently had an issue with our system same gimbal as yours - It wouldn't pick up...
Hi Everyone
Phantom 2 with a lightbridge..
Question for experienced pros out there with the ground station -
Will the iPad Ground station conflict with the lightbridge operating frequencies - it appears the lightbridge operates in more of the ISM band, where as the ground station appears to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.