Recent content by Liquidwayno

Hey everyone. I have recently been told to reflash my NAZA M. The problem is that I have no clue what that means or how to do it. Here is what I was asking in a recent post but have decided to repost in Help instaed of general. I upgraded to the NAZA M 2.2 software in order to troubleshoot a...

Miskatonic, I appreciate the help but I am a newbie and have no clue what re flashing is or how to set about doing so. Please forgive me. Is there a tutorial or YouTube video explains this?

Hey gang, I upgraded to the NAZA M 2.2 software in order to troubleshoot a motor issue. Now I cannot get the compass to calibrate properly. When I attempt to calibrate the first turn of the Phantom 360 deg horizontally I get a nice solid green light. The Second calibration turn vertically...

Thanks Driffill. I hope that is all it takes. The motor I soldered directly onto the PCB works fine. The motor in question had the wires attached with the wire to wire solder joint technique. I tried this technique to ensure the wire colors matched and because the direct to PCB technique...

I have not been able to hover. The **** thing just flips over forward left. Ruined my two forward props that were carbon fiber.

Okay. I learned to solder and replaced the motors. Everything is back together and the advanced diagnostic has been run. The problem now is that the right aft motor seems to have more lift or is stronger. The entire unit wants to lift there first. It almost flipped over before take off. When...

Hey gang. After a rather horrendous crash I had to order a new shell. After re installing all of my components on the new shell I noticed that hardly any of the new hardware was appropriate. I reused the screws for the motors having had prop guards on the old shell. I did the same stupid ****...