Hi,
I would appreciate immensely if anyone can help. I had a crash today with the gimbal attached (H3 3D). It was not too badly damaged and I have it physically repaired. When I turned the Phantom on however the gimbal went crazy and just wouldn't stabilise. I managed to undertake successfully...
thanks for the response folks...it does still leave me a bit perplexed. I did read the article on your link jadebox, thanks for that. I do have prop-guards as it happens which I read tends to promote VRS. I'm still a bit confused on my initial question though. I did not read anywhere that...
Hello good people,
I have something of a 'newbie' question...I have about 5 hours flying with the Phantom 2 so I'm getting the hang of it.
Yesterday however I was doing a quick descent from about 100 feet. I pulled the left stick fully back, probably about 7 seconds. When I let go and stick...
folks, Harry - thank you for your help. Got it working, but I do feel a bit foolish...was getting a single flashing green light for a while which I thought was an error - I had thought that I needed a solid green light (I know now that's just immediately after gps lock and then it goes to flashing)
been trying to get this value below 300 for about an hour now...it does happen and I calibrate at that point but it won't stay below 300. Connecting five minutes later gives me same problem, over 300. I can get a single green flashing light only - no gps lock. I wonder is my compass faulty
Hi folks, looking for a bit of help. Phantom 2, not crashed. Was running perfectly until I attached it to the PC and started messing around with the software. I engaged IOC then disengaged it and tinkered with a few other things. Undertook a couple of advanced IMU calibrations. I cannot now...
thanks Irishsights - I see you're in Bangor. I was just about to post a message looking for NI flyers. I'm in Bangor quite often - we should hook up some time. I have P2 with 3D gimbal and Hero3, 8" monitor (not tried this yet) and iOSD mini.
Hopefully I'll get this thing flying again shortly...
thanks for this info 4wd...I tend to think myself it's to do with sticks calibration as I did have an 'error 29' reported which asked me to do a sticks calibration. I thought I did this correctly. I don't understand though what exactly you mean by 'calibrate the received signal'. How exactly do...
Hi,
just tried to engage ioc mode but when I unplug the USB and try to start the aircraft I get a single yellow intermittent flash and I'm unable to power up the props. I reset to Phantom mode in the Phantom Assistant software v3.2 but I can't get a solid green light indicating GPS lock. I have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.