Recent content by leptit

that's what i did , I know i should see it . A guy that reboot his H3-3D says it : * "Let the software flash the firmware to the H3-3D IMU, and once it has done this, power cycle the Phantom. If you still cannot see the H3-3D IMU in the Phantom Assistant, try the Windows version of the...

nothing , still have not seen "H3-3D IMU" : I've do factory reset , plug drone , open assistant , login , but it show me the same thing IT's like the H3-3D is powered , but can't communicate with drone or assistant

ok sorry i'm desasperate , i will test

no , why it will change something ?

tell me if my H3-3D is dead , because i'm log in the assistant , i can't see "H3-3D IMU" when i do reset ( while before i could ) I don't think it's a problem with assistant ( or tell me because i'm lost ) I think when a bit of water come between the connexion therefor the cervo was dead or...

I don't know if you understand : I change the cable because when i use the drone in snow , the gimbal begin crazy , when i want to chek the gimbal after in my house , one of the connexion between the motor and the cable start to smoke , i look at the cable , the connexion have burnd so i change...

no i'm every time logged in the assistant , you tell me : you need to log every time , so as i can't log out i create a new account but i can change the first one

I create another account but i can't log in the assistant , it stay on the same account ... I understant nothing .. i just want a good gimbal , if i buy a new one will it work ? Or is something with my P2 ? if i can't see the H3-3D IMU in " upgrade section " my gimbal is dead ? I don't want to...

i feel bad , i don't see the difference between log every time or using remenber me :( Before i change the cable , the zenmuse goes crazy but every time i do a factory reset i saw the "H3-3D imu"

jason i have this message but i chek "remember me" , I have download this : windows dji driver V 2.02 , dji RC system asisstant V 1.2 , dji zenmuse assistant V1.4 , and the dji asstsiant V3.8 what i need ? I'Have an account on dji.com and i'm every time connected in assistant , what i do wrong ...

all the cable is ok , i can't see why my assistant can't do the update ? :( In the assistant zenmuse i have no information

I am registered , i have an account , i have all the firmware. IT's juste since I change the ribbon cable i don't see the upgrade for the "H3-3D IMU"

yes i have , the thing is , before i change the cable , i saw the " H3-3D IMU" but now i dont

no it was the cable for the motor , the big one , i change the little one for the the camera too

DJI Phantom Zenmuse H3-3D Gimbal Camera Ribbon Flex Cable Replacement Spare Part | eBay this one , but ,like before , after remplacement the H3-3D is not responsive