Recent content by latecomer

  1. L

    Gimbal dead after update

    Update, I watched the video and did as instructed, the first time I did it I didn't follow the instructions explicitly like he did on the video and it didn't work (after I bridged the contacts, I turned the Phantom off, reinstalled my GoPro and then turned it on and plugged it in). I tried it a...
  2. L

    Gimbal dead after update

    I have the same issue, plugged my phantom 2 in, downloaded the update and now Ive got no power to my gimbal.
  3. L

    NEW DJI P330CB Firmware 1.0.2.8 block old lipos

    Could you further explain this? Specifically, what is a lipo? The reason Im asking is that I pluged my Phantom 2 with H3 3D gimbal in today, I was informed that there was a recent update to the firmware that I believe it claimed to helped resolve issues with the gimbal. I installed the update...
  4. L

    DJI Upgrade Board has CAN bus?

    so i had to add about 3" of wire to make it reach. the sheilding, how important is that? At present I have about 3" of unsheilded wire, the sheild is not restored.
  5. L

    DJI Upgrade Board has CAN bus?

    I am getting ready to install the data link for ground station, when I set up my fpv i pulled the can bus connector cable up the leg and and reconnected it inside the Phantom 2, I also have my iOSD inside my phantom. Now I would like to set the air end of the data link on the outside but alas...
  6. L

    Controller X1 Doesn't Calibrate

    I just came across this post and Id like to ask you some questions if I could. I too just received my Phantom 2 with gimbal. I too am awaiting the delivery of a GoPro 3+ camera. I put the phantom together minus the gimbal, I put brand new batteries in the controler but when I turn it on I get...
  7. L

    Rage Cam lens advice

    There is a company called Peau Productions that sells the lens for $120 plus around $10. for shipping.