This may sound stupid but are you wearing a watch? This happened to me after I changed my band from rubber to SS band on my Apple Watch - believe it or not... replicates every time with watch on. Took me awhile to figure out what was happening... Launched and calibrated from same spot for...
IDK... 3 tries with watch on = fail
1st try watch off = all good
I don't Believe I have had my watch on calibrating the compass before.
Watch was close to P3P as I was spinning it around? Hand to hand... Maybe?
I used to just hold bird and spin myself, but I get dizzy easy... Lol
I just did a search for Apple Watch and found this Tread...
I just did firmware upgrade - IMU calibration - went outside as usual to recalibrate the compass in the same spot as always - nothing around as noted at all. Calibration failed 3 times - UGH!!! WTF!!!
Then I realized, I was wearing my...
Wow! Pretty harsh guys? The poor guy crashed his P3 - Yes it was obviously his fault for flying where he was but... Where is the compassion ? He was just asking for help understanding what happened. Sorry Aaron for your crash - live and learn - lucky no one was hurt - hope you can get it repaired.
OK - I am in Florida - hot as hell all summer - 90+ everyday. Winters pretty warm all the time also...
Forget about it inside a car.
Honey, lets take the kids to visit our relatives on the other coast! (of Florida) just a four hour ride...
I want to take My Phantom 3P to get some videos and...
I do sometimes... Try this - works for me.
Put your thumb tip at the bottom of the stick with thumb resting on white part of RC and rest of thumb resting on bottom black section at bottom of stick - push and hold gently - Helps me to do totally slow smooth Pans (yaws) - I mainly only use this...
Not as bad as I used to be when younger "OCD" LOL! Just that it can make any new person flying $1300+ a bit nervous about flushing it :-)
I flew it with and without guards and didn't notice any major difference myself, but I am a fairly new pilot.
And COM'ON.... Didn't you ever go back to...
Not really familiar with Bondic - I see it IS heat resistant - is it best used for just cracks, like welding or can it be applied as a filler like epoxy? I was hoping to find a heat resistant plastic epoxy and fill around all for motor mounts (along with my 4 screw prop guard mounts) to try and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.