Recent content by Large

I'm not sure, I wish I had an answer. I hooked everything up traditionally, and everything works fine. S-bus is another story. I will keep messing with it as I have 2 more hexas on the way with another naza m lite and v2. All with the same Tx/Rx.

Apparently you can't use the Sbus feature on this radio/receiver combo with the naza lite. I am not the only one with this issue, this user on this page (translated with google) is having the same issue. Works fine in traditional mode, not so much in D-bus...

On the Rx it says 'S.BUS2' for the slot you are describing, which I was under the assumption that it does not work with the Naza.

Rx and Tx are bound - yes. Servo wiring from X2 on Naza to S-bus on Rx, D-bus is selected in naza software I went as far as I could with the programming. From off the bat though I cannot go further than a couple of steps in due to not being able to get any control input, but I went ahead and...

I guess a picture is worth 1000 words. However, even after having only the 1 cord from 8/SB to X2 I still am not getting any input on the computer screen.

Connection settins, A-1 E-2 T-3 R-4 U-5 X1-6 X2-8/SB Also I changed channel modes (there are 4 - A, B, C & D). Tried them all and I have the same results across all 4 modes.

The PPM option does the same thing as the D-Bus option, it does not show on the comp screen that I am hitting buttons / physically moving the throttle stick, etc. The horizontal input on the receiver is an S-Bus 2 connection which I read somewhere that the Naza lite does not support yet. On this...

Thank you all for the help / replies. I've cycled power to the Rx/Tx probably 20 times or so. The Rx is showing when it's connected to the Tx with the LED light on it. I've bound the Tx to the Rx probably 3 or 4 times already. I did notice that when switching to Tradition from D-bus, in the Naza...

Thanks bud. I read the entire guide a few times over to make sure I didn't miss anything. I've double and triple checked my wiring and connections and everything is 100% complete. I will search for 10J on here to see if I can get a hit, thank you.

Hello all, Any advice on connecting my Futaba T10J to the receiver (R3008SB) on my hexa? The battery is plugged in to the hexa which is also plugged in to the computer and here is where I am stuck. When I turn the radio ON, you can see the receiver light turn from red to green, but when I try...