Recent content by LamboH

  1. LamboH

    Magnetic lock on yaw arm

    Try holding like this and firmly grabbing the camera body with other hand Or very carefully pry open with plastic pry tools or super very carefully with small flat head
  2. LamboH

    Magnetic lock on yaw arm

    should be able to pull apart from the other side just with bare hands. It separates and connects back together pretty solid but I was still able to separate by pulling apart the two Should end up looking like this
  3. LamboH

    Got My Phantom Back, BUT...

    the heat is probabaly from the vps system...as far as aircraft warming up taking long....stick your phantom in the freezer for about ten minutes and run a cold IMU calibration. usualy this fixes AIRCRAFT WARMING Up taking long time.
  4. LamboH

    Using 4K camera on the P3 Advanced

    Have a gimbal main board and the rest of my camera( p3p 4K ) the camera separated at the yaw arm and can be fixed with a new yaw arm and cable. If anyone is interested pm me.
  5. LamboH

    NFZ but still able to fly....

    Around my parents house is within 5 miles of a tower controlled airport .it says nfz as soon as the app opens. I guess being within 5 miles of a nfz it still lets u fly but warns you of the location ( and you're suppose to call and check in with control tower . I think if you're at/ or less than...
  6. LamboH

    I broke the ribbon cable for the remote

    Looks like it just got disconnected. U would need to flip the black tab on the connection up- then carefully insert the ribbon cable - then flip the black locking tab down . For those in the know , I actually broke my ribbon cable connection(part with the harness and the black locking tab...
  7. LamboH

    No Go on DJI Go

    4s doesn't have the processing power nor no where near enough system ram .ipad mini 2 even though supported barely has enough oomph in it to run Dji go imho. My iPhone 6s handles the job a lot better than iPad mini2
  8. LamboH

    Stripped set screw for gimbal yaw arm

    Yea no doubt. I would definitely try the pick and manually spin it out. The screw itself is short so not that many threads overall . I've successfully backed out some set screws that were put under a lot of pressure. Same set screw under a lot of pressure also dealt with very high temps( thus...
  9. LamboH

    Stripped set screw for gimbal yaw arm

    I think u may be correct. The correct size for the screw is 1.5 mm allen (hex head) Early morning brain fart
  10. LamboH

    Stripped set screw for gimbal yaw arm

    One last machinist trick to back out a stripped set screw -( rarely works but when it does ---talk about CLUTCH ) Get a small pick with a sharp pointy point to it . You can grind down an old small screw driver etc . Get in their with the pick and try to spin the the set screw out . Pushing /...
  11. LamboH

    Stripped set screw for gimbal yaw arm

    Your set screw in question . Little bitty thing
  12. LamboH

    Stripped set screw for gimbal yaw arm

    That set screw is so it holds the roll arm in place ( holds in place up and down and the shaft its on has a flat milled out so the set screw can catch. Try twisting the roll arm slightly, while holding the top gimbal board securely . ( trying to twist the rolls arm and set screw off the flat on...
  13. LamboH

    Stripped set screw for gimbal yaw arm

    Go next siZe up on screw driver. I believe u are looking for a Torx head screw t-6 possibly. Try t7/t8. And give it a go. If that doesn't work , try using an old t-6/t-7 screw driver and grind the tip off( to where what's left is beefier- more area for it to grip on ). Last but lot...
  14. LamboH

    Launching from a boat

    Ditto calibrate on land before hand if possible Dji actually recommends u take off in atti. Yet they also advised to not fly over water !!!!
  15. LamboH

    Launching from a boat

    To each their own but for me I like to gauge wind. Wind speed and direction changes a lot and at lower altitudes (guess being on the coast ) so when the birds really far out hard to judge how to phantoms is reacting to the wind (in gps) when far out . I always fly in atti even over land...