Recent content by la_panza

mine had a bad wifi transmitter too... now it's OK!

Hello, please have a look at this video.. please explain what's happening to my RangeExtender..it has been working for some time.. then WiFi disappeared and now it shows a cyclic long flash on the green LED every 5 seconds or so, it does not change its behaviour even if I press the hard reset...

thanks... I tried .. no luck... I returned the copter and waiting ti have it back...

AND....YESS!! photos and video are recorded!!! must be an app issue...

same problem here, black screen with endless spinning circle in the middle.. the LED in the gimbal shoots a green short flash every 2 seconds, gimbal can be tilted and telemetry data are received normally..

thanks a lot, I feared it was a new bug-gift from Dji latest effort :-)

After the firmware upgrade i could not start the motors because am ESC Status Error.. after two or three IMU calibrations and many power cycle it seems to be gone... just to share my experience.. Still i have to find the courage to take the phantom out and fly since the firmware upgrade.. too...

after the firmware upgrade, every time I turn the Phantom, the Phone and RC ON I find thet C1 and C2 have returned to their default setting.. is there any procedure to save them permanently?

Please do an eperiment.. remove props. leave the Phantom on your table, then take off.. leave the stick free. in the resting position. turn off RC, motors keep spinning at low speed... now switch the RC back on.. the motors STOP! I wonder.. could this happen while phantom is in the air, for...

thanks for replying, I will look for a Photo I took some days ago, perhaps I didi it in the same place.. if I find it I'll post the two pictures here, the filter and camera show absolutely no scratch, tick or ding, gimbals works and the arm is not bent, the drone hit the ground with its upper...

Hello, yesteerday I hit a tree, the Phantom 3 pro fell upside-down from 10 meters (40 feet) on a meadow with little grass. did not report big evident damages, but I have the impression that picture is not as neat and crisp as before... since I have experienced a dramatic loss os focus after a...

Yes, that's what I did, I simply dropped the drone on the table on its arms,. from 20 centimeter high.. ad it did work!! thanks everybody for these hints...

please see the photo attached... excuse me if it's rotated by 90° :-) mod is quite High as you can see, but I really don't know what's the normal range... wher is physically the device to "tap"? can you please explain with some more detail what I should do? thanks :-)

Hello, I hit a Tree and had a crash, it seemed not to be a catastrophic one, the Phantom 3 pro fell on a meadow, only the gimbal connector was pulled out.. After recionecting the Giimbal I have red-yellow-green quick LED sequence, the app reports "MC Data Error", the Overall Status page reports...

C1 map - camera view C2 gimbal forward - down