Recent content by Killabear

no problem, here it is! http://www.filedropper.com/rcoriginal

You have to remove gimbal panel (a few screws) and than you will see the contacts. Names are the same as in RC - TXD, RXD, GND. Photos are in the first post here.

So, my case is solved. The problem was that i made i mistake while connecting cables - GND was TX and TX was GND. It was easy to missmatch because contact names are located very close to each other. Then i stopped booting process (esc worked) and loaded backup copy of the system and mounted -t...

nice... chinese engineering.... ordered two more UARTs, one is the same that i have and other is a bit different, i will try them tonight and response..

Thanks! As i thought, it is problem in the UART. Did you tried different models or same models but different sellers?

Hello Steve! DBS mod does increase the range, but it does not increase the penetration of the signal. So if you are flying in the field where are not much interference signals, the range will definitely will be increased to 2000m (6000feet) but in the residential area, where are a lot of wifi...

Hello guys! I am new on this forum. Have the same problem - tried to do the range mod with ftp but didnt use notepad++ (actually i did it with standart notepad from windows 10) and after that my RC and bird became bricks. So i bought the correct UART (2102), solded tx, rx and gnd to the rc wifi...