I have a good battery phantom 3
then i unplug the three jack (signal jack and 2 power jack 1,2,3) and plug other batter but it not work.
And finaly I put this mainboard to the first battery and it didn't work too
when i power on the battery, four led flash but not power output
when i charger...
I have a good battery phantom 3
then i unplug the three jack (signal jack and 2 power jack 1,2,3) and plug other battery(dji battery phantom 3 too) but it not work.
And finaly I put this mainboard to the first battery and it didn't work too
when i power on the battery, four led flash but there...
I have phantom 3s, 3adv and 3 pro. I have 1 battery of phantom 2.
Someday, i test using battery pt2 for mainboard pt3s and it work and 4 rotor run, but i have no take-off.
So what happen after i take-off pt3s with pt2 battery? maybe it cash or some thing?
I have this problem:
when i start the aircaft, everthing fine. But when i take-off, the error ESC like picture below.
Please tell me what happen?
sssd|none
i have pt3adv down on air and crack the jack compass to mainboard, i try to
sticky the jack and i have compass error like this, i try to change another place but still error again
aaa|none
com|none
then i change the compass pt3adv by a compass of phantom 3 standard, but it still error again...
to night i put 10 connector and it is work, but have error compass.
Then i calibration compass, but it is error like the picture.
how can i solve it ?
loi|none
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.