Recent content by keevan

No manual motor start "SOLVED". On Oct.31 I went out to fly and as usual tried csc motor start before resorting to auto take off but motors started manually. What a surprise, Checked other 2 drones and both now had manual motor start. Not sure but this problem started after flying over a...

Reviewed CSC video and tried sticks over & over many ways and waited a couple seconds after each try and nothing. Tried 10 miles away to check for no fly zone and nothing. Used auto take off to try my new itilite antenna and was very impressed to fly 1&1/2 miles away with no loss of signal...

Applied custom settings and nothing happened. Changed back to mode 2 and again nothing happened. All items were on and built custom mode matching mode 2.

Got to master stick mode on ipad mini and nothing happens when I press "Apply". It shows a check mark on mode 2 and still no motor start.

Can not get to "Master Stick Mode" on my tablet. I will try on my ipad mini and see if that will work.

Yes, the CSC still works to stop the motors but once stopped, they will not restart unless I use auto take off again.

All 3 phantoms show controller settings as mode 2. Still no resolution.

Could you tell me how to change that mode on the aircraft.

Calibrated RC & did firmware upgrade. calibrated ac and did twice because did not hit button during timer count down. got new ipad mini 4 for better dji go downloads. reviewed video on how to start motors. Still have to use auto take off to fly.

My 2 p3a's & 1 p3p have recently not been able to manually start the motors. All 3 will still fly using "auto take off". Have tried numerous app downloads and firmware upgrades and nothing changes. Posted on phantom 3 help and numerous replies can not solve the problem. Has anyone else seen this...

Just got ipad mini 4 and works great. Connects fast and video good. Well worth the extra money. Scraped my galaxy tab e.

Tried calibration method and got ok and did it twice but still no response to sticks for motor start. But I can still fly using auto take off.

Summary No.4 All of the new drones would start and fly manually. Never had to use auto take off. always used the CSC method. Only recently did the CSC method fail to start the motors. Somehow all 3 failed to start manually at the same time. I will try the DroneFly rc calibration method as I was...