Recent content by keenan

  1. K

    What DJI Got Wrong With the Phantom 4

    Love the idea of lens protection and auto record....
  2. K

    Gimbal

    No, but I calibrated the X1, and this moves when I move the lever on the bottom of the RC. did not think to use the GUI for the gimbal itself, as this gimbal is a chineese one, and people tell me that if I attempt to run any GUI with this board, I will completely damage the board, as it is a...
  3. K

    CNC Gimbal Calibration Issues

    If you have a close look on the circuit board of the gimbal, you will see a reset switch. Have you tried this? Once you press it, hold the gimbal in the level position. The gimbal should start up and remain level.
  4. K

    Gimbal

    Hello. I'm hoping someone can help me. I have a Phantom V1.1.1 with a chineese gimbal, using a Gopro Hero 3+. I do not have any pitch (tilt) on the gimbal. I have enabled the gimbal switch in the Naza software, installed the signal wire to the bottom of the F2 port on the Naza board, and the...