My ArialFreaks Cyclops gimbal needs a new brushless motor (pin sheared off one of the motors after a crash).
What is the model number of these motors? Or...can they be replace with another brushless motor?
Thanks, :)
Thanks for the inquiry,
As it turned out, the arm that is connected to the "roll" motor was just loose enough to be causing the vibration. When I tightened it the hollow arm bent a bit, so I unscrewed the hex-bolt that held it in place and wrapped a small, thin piece of rubber around the arm...
I need help....
My DJI phantom 2 vision (with aftermarket gimbal -- Cyclops Vision Brushless Gimbal for Phantom Vision [AF-CVG]) has got a very shaky camera. I noticed this phenomenon shortly after the quad had crashed into a building (sorry, no footage of that). I found it upside down and...
Hello all,
I need help with the following issue: the camera tilt servo is stuck pointing down.
Here's what happened (short version): My DJI Phantom 2 Vision (non-plus) fell from about 8 ft causing the camera's gimbal cable (3-wire ribbon cable) to disconnect and the battery to become dislodged...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.