Ok..so I will say...the first time through..it is not super simple..I am dumb with stuff like this, but I did mine...and YES...start with the camera side, because you have to wrap it around the camera arm one full time then go to the other end..also, do NOT take off any of the adhesive tape...
I actually just experienced the same with my P3A. I hit a tree and broke the same arm. Replaced it myself for about 30. Had to replace the arm and the ribbon. Took me about 5-6 hours to fix it. If I had to do it again, I could prob do it in about an hour or so. If you get it repaired with...
I recently replaced my flex ribbon on the gimble for my P3A. The issue is that I had to reseat it several times that the adhesive is not holding at all anymore. I am looking for an alternative to re-secure the ribbon to the gimble arm. I have looked at clear silicone for electronics, 3M...
I recently replaced my Flex Ribbon and have misplaced a screw. Does anyone know this size or screw type for the one in the picture? Not sure what this part of the Gimble is called. Thank you so much for any help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.