I want to modify the battery on my P2V+ to enable dual batteries. I have seen batteries that have been modified to do this, but I want to do this myself and don't know where to attach the new leads to the battery. I already have the battery case removed. Any help would be appreciated.
So JDot have you flown with the new bearings? What were the results? I thinking of doing this mod to increase range and duration without the extra weigh of additional batteries.
I just found this in another thread.
underneath the P2 there is a small blinking light (red). keep controller off and turn on a bird. now use small screwdriver and press
that blinking light (it's a button switch) and hold until it starts blinking yellow. now turn the controller on.
VOILA...
From my limited experience, if you need to rebind the transmitter to the drone you should see a small red light on the side of the drone. I'm not at home to see which side. Follow the directions in the manual if you need to rebind it.
Ok I replaced the gps module. In assistant it shows -.-.-.- for the loader. And 6.1.1.2 for hardware ID and 6.0.1.6 for firmware. I pressed the upgrade all button and received a message all we up to date. Any ideas!
I installed the new 4mm patch antennae and tested with the top shell off. Had 6 satellites. I was unable to calibrate the compass so I followed the instructions for de gaussing the compass and resolved that issue. Now I see no satellites and the DJI app says Ok to fly but no gps. The lights...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.