Recent content by Jim Gordon

Thank you gentleman. Your response in regards to this situation was informational. I think the limit warning was due to I didn't fly for 6 days, and I should have made sure battery was fully charged. I charged battery full and did a test flight and no limit warning this time. Thank you all.

Yes...now when i think about it...it said limited and not spec.. Does this mean my battery is bad. I was at 70 % when message appeared

I had a warning pop up in my go app,,"Propulsion out of spec" appeared while flying. Everything seems normal, no crashes/hard landings or cracks. any thoughts why this warning appeared? thanks Jim

Good to hear. !

Hold buttons, launch app...let go of buttons after app is launched. You should see that you can then install the upgraded firmware. I did this 3 times before it worked. Let me know

T Thanks, very helpful guidance from you all and a dji support tech. Thanks again, Jim

Issue resolved I did the c1 - c2 force install procedure, and it took this time. All is good. I should mention , that I did initiate the above procedure several times in the past few days with no luck, not even going to start to understand this Issue I had, happy it works again!

I have had 1.6 o the bird for 6 weeks ,no issues at all.

I should add that if I go to-about- in the go app, I no longer have any info about the bird in relationship to firmware status, this simply means no communication is happening between bird and rc I believe

Hi John, yes if i go to- about- it says i have latest firmware, I also have a red banner no signal , after I successfully installed 1.5.7 , The status color on the rc after 1.5.7 was installed went to a very light blue color, and stays solid , no matter what binding procedures I have tried...

I also uninstalled the go app, re installed, tried different usb cable, my wifes phone. same results. the bird flashes yellow blinking status lights, and red light on gimball/camera. app says rc is updated to latest 1.5.7 but it is locked tight.

thanks for the reply. Yes I did the 1.5.7 rc firmware upgrade from the go app. I do not believe you can do it any other way. soon as I did that my rc froze, and that was that, locked tight. I did the exact steps above and the one where you hold c1 c2 and shutter button , power cycle rc offf...

the other day I was prompted to do a upgrade to my p3a rc controller in the go app. I did the upload and started the upgrade process. Now I have nothing,no signal, no communication between bird ..& Rc. I have tried all the possible binding procedures, but because the rc is locked, solid...

Hi,. Just had this exact same thing happen to me. GRRR, Exactly what you describe. not sure what to do...just bought 1 month ago. Jim