Recent content by JH_PiNoY

Short is possible, if it goes through the small vent holes. Once you come back in, the snow might melt and get some water to contact some of the electronics

GOPRO APP

Those are 9x4.5 props. My suggestions were 9x 4.3 props. With 9450 props, you wont get any increase in flight time.

I would suggest you get 9443 P2 props from B&H. Its genuine products. Fully loaded with gopro and fatshark system I get exactly 9 1/2 mins of flight. In short, it increases your flight time by a whole min compared to using stock props.

At the time this picture was taken, my fatshark setup was not installed yet. I like having the battery wires out for 2 reasons. One, im just not a fun of kinking up my wires in the Phantom. Soon or later you'll have a weak spot in the wiring. Second, I like plugging in the battery as the...

My stock 1.1.1 tx reached past a mile at an empty farm field. You really just have to make sure your antenna is horizontal not vertical. Having the antenna with this orientation is similar as a high gain antenna because your transmission projection is EXTREMELY narrow, so you have to be directly...

My phantom weighs exactly 2.9375lbs (2 lbs 15oz) or 1332 grams with a setup of handheld G3 gimbal, fpv, gopro, 2200mah lipo. Ive done this setup a couple of times just for fun just for cinematic type shots. Its more than capable of carrying this weight. The only "mod" i've really added are 9"...

Not really customized yet, still stock. The only thing thats not in the picture is my fatshark setup.

I discharge my 2200 mah lipo up to 11.25v = 3.75v per cell. Its a good safe number, I believe thats about 80% discharge. Dji Phantom 1.1.1 -P2 vision props -Fatshark 250mw -GoPro This setup gives me 9 min flight time = usually my voltmeter reads 11.28v immediately after the flight.

I agree^ 3-4 mins max! Overall weight of 3lbs is all it can carry. The p1 weights just about 2lbs with a gopro

I highly recommend the Airblades antenna by IBcrazy. Reached 1.13 miles, no point of flying that far but just wanted to see how far it could go. Could have went further, no static at all. -Dji 1.1.1 stock

Yes, i have had the EXACT same problem with my Boscam video system and Dji System. I also wasnt sure if it was defect or normal. I also had a problem with really bad interference after 300ft or 100m. After many hours of research online I found out that Boscam system does not have a strong filter...

The receiver module you bought is useless without googles but the receiver you posted above can be directly connected to your monitor. Quick tip, Immersion RC products and Fatshark products are compatible.

If you want your fatshark googles connected to a monitor you need this cable. http://www.getfpv.com/fatshark-video-only-rca-to-2m-jack-cable.html Its a simple setup, just connect this cable underneath the googles and connect the other end to your monitor. The monitor will project exact what you...

Here's how mine is setup. Kinda a bad angle but looks pretty clean in the air no wires dangling everywhere. I wouldnt really suggest putting another battery on the P1 just to power tx, it'll be too much weight. With powering up the monitor, change the leads to an xt60 connector so that you can...