Recent content by jejeje

  1. J

    CSC/Stopping/Starting motors.

    Four CSC commands listed in a manual of NAZA-M are all effective in Vision+.
  2. J

    Stuck SD card in P2V+

    I did same experience in old Vision, too. I remember that I polish a retractable knife thinly and stick in to a slot and took out an SD card. The 32GB card of SanDisk thinks that gold and red painting may be thick a little. So, I tear off the black tape of the card undersurface (the side where a...
  3. J

    Freefall then crash!

    A motor cannot stop current Vision,Vision+,Phantom2 by operation with a throttle as less than 10% during flight. According to the manual of NAZA-M, motor stop operation has 2 mode of "Immediately" and "Intelligent". It becomes the motor stop by one operation mentioned above at the time of the...
  4. J

    Central Board firmware version up

    All forum members, nice to meet you. I am a phantom pilot resident in Japan. Please forgive my poor english,thanks. :) It is not listed in the homepage of DJI, but the firmware of the central board revises it. (V1.0.1.27)) I thought contents of the update probably "to have been the improvement...