So I am completely fixed now, this is what I did.
I flashed again my h3-3d by shorting the pins. the top right and middle, not the top left and middle as shown in some other tutorials.
I downloaded the new firmware 3.4 (3.6 is out two days later now and I haven't updated to that yet) and...
ok. so i used the extra cable that came with the gimbal and bypassed the filter board, still nothing so its not the filter board and its not the long or short cable.
its 100% a problem with the gimbal.
Any ideas
J
I don't think its firmware because today i managed after about 20 reboots to get it to connect to the assistant. I upgraded to 1.0.0.10 and on restart its still just hanging there doing nothing with the green light on.
I think it may be the zenmuse grey cable, maybe one of the terminals or...
Yeah I thought about that too, no i haven't but it isn't that off tbh. it only rocks forward (downwards) and to the right (usb port side) very very slightly when turned off.
J
I purchased brand new H3-3D a couple days ago, fitted it to my P2 with GoPro 4 and had one! amazing flight with the current setup
P2
IOS Mini
Black mamba Flysight TX
THEN I took it home as I wanted to customize the P2 settings a little more and I was promoted for the update I then upgraded the...
Re: HELP! HELP!? Anti-interf. board-which end feeds gimbal??
When building an LC filter, the capacitor is ALWAYS on the output side and the inductor (choke) is always on the input side.
You have to remember that this filter is only effecting one wire, the positive DC. and uses -DC (ground)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.