Recent content by Jan Kubka

Yes, I was watching. Phantom 4 Pro V2 is not listed.

The main reason is the possibility to adjust the Yaw Endpoint below 30 in the developer mode in DJI Assistant 2 1.1.2. This greatly simplifies the control of the drone. But there are other advantages, but this one is the most important for me. The latest firmware version does not work with this...

Can I downgrade the firmware of Phantom 4 Pro v2.0 from the latest version 01.00.50.00 to an older version? This is not possible with DJI Assistant, and it's not possible with Dumldore either. DJI seems to have blocked the downgrade option.

Can anyone advise me how to slow Yaw speed (Sensitivity - Endpoint) below 30 on Phantom 4 Pro V2.0? I know there is a Super Patcher, but I can't use it because I control the drone with Smart Controller, which requires firmver V01.00.20.00 and higher (added OcuSync 2.0 support), while Super...

I bought a Smart Controller for my P4PV2, which is newly supported. Can anyone advise me how to configure the right rotary knob to control the aperture, as with the original Controller for the Phantom 4 Pro? Only the tilt of the gimbal can be controlled with it. The aperture can only be...

It is not the problem of the screen dead zone.

I tried, but doesnt help...still the same problem. All other functions work fine.

I cannot switch between photo and video mode by pressing the icon in the app without restarting the aircraft before fly. If I press record buttom on the RC, it is works, but I cannot switch between photo and video from the app. If I restart the aircraft before fly (RC and tablet ON - connect...

I did everything you recommend. It si more better, but not perfect. If I fly in open air, it si fine, but when a drone is not in sight, for example, behind trees, I'm losing the signal. I flew three batteries, I'll continue to test.

I will do that. I also reset my tablet to factory settings. I have several cables, the result is always the same. If the weather so permits, I'll try it today in the air.

Hi everybody. I have also a big problem with signal transmition between my Phantom 4 Pro and my Android device Nexus 7 II (2013) with Android version 6.0.1. I have installed last versions of Phantom firmware and current version of DJI GO 4 v. 4.1.8. My drone cannot fly more than 200 metres...

Unfortunately with the second set of propellers is it the same :-(. Still not stable....

I will try. But propellers looks fine.

Over the last few weeks I have been watching the jitter during the flight (video below) with my Phantom 4 Pro. I've tried everything to remove the bug - I calibrated the gimbal, IMU, controller, restore to default settings, upgrade to new FW v 01.04.0602, downgrade to previous FW. The flaw...

Yes, ok. Calibration it is not necesery. But I think that cannot be the reason of my problem with unstable fly. Do you have some advice how to solve that?