Hey buddy going by the amount of damage that you say I would give an offer of 300.00 sounds like the only good things are 3 motors and the naza do you have pics
Thanks Jake
I put my naza system in my df 250 and it is a real tight fit with some mod but it works so nice , not bashing but these other guys using cheap boards and it shows while mine is rock steady . I use my df250 as a race car it screams all over the place down low and fpv a ton of fun I say go for it...
Hey zeety mine just started doing the same wobble ,this is not a vibration it is a pure wobble I still have not figured it out yet but glad to see I'm not alone . So far I have done the following advanced calibration , compass reset recal. Radio and also inspected to make sure the board did...
Re: 3d printed landing gear
I am waiting for my maker bot fifth edition to show up I bit the bullet and bought the lay me down version it was more than I wanted to spend but it will be worth it ,that's what I keep telling myself. I offed the guy that started this thread to print this for him...
I'm in the same boat I can't figure it out if I do I will post it everything I do upgrade it says it took than when I plug I the quad it says need to do update but I already have done it several times ?
I got the easy osd and love it I did mount mine outside which was easier and makes it accessible to the buttons very happy with it . The disadvantage is the GPS is slow but I can deal with that , would I do it again (yes)
Yes I have had the same experance with them took for ever to get my stuff and there CS is not good at all , they will come thru just takes time and I had the same on the shipping good luck
So far as what I Have read I'm thankful I have not done the update I'm still running 2.02 . Lets say you have 2 computers one has 2.02 and the other with 3.10 update can u update with one and take it back to 2.02 with the other computer or will it not let you revert back to the old software ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.