Recent content by impilot51

Aledo here. Have a P3P, happy to show you the basics. Sent from my iPhone using PhantomPilots

My guess is to clear the rear props and still have the camera at a level higher than the props. Sent from my iPhone using PhantomPilots

Same here....no problems with iOS 10, both on an iPhone 6s Plus and on an iPad Air 2. Tested with Go, Litchi and Autopilot. [emoji106][emoji106][emoji106] Sent from my iPad using PhantomPilots

Works fine for me on iPad Air 2 and iPhone 6s Plus. Sent from my iPad using PhantomPilots

I have upgraded. Running older version of Go, 2.4.2. Flew 2 batteries thus afternoon, no issues on iPhone 6s Plus. Sent from my iPad using PhantomPilots

Bricking issue now fixed.. Was over the air only, iTunes connect fixed. But problem has been fixed and over the air upgrades are working. Sent from my iPad using PhantomPilots

The tool is really to remove props, not to tighten them. You run a real risk of thread damage doing this. Tighten the prop roughly 1/8 of a turn past when it stops on its own if you spin them on. That's plenty tight. Sent from my iPhone using PhantomPilots

Now, no barometer in that iPad. Sent from my iPhone using PhantomPilots

Then you have a defective iPad. The Ellipsis 10 gets horrible ratings from people that own it all over the place. But hey, whatever works for ya, I just don't like dedicated devices. I prefer to buy one tablet that does everything I want to do. And once you are there, I sure don't would not want...

Ya know what..to the mods...how many times do we have to go round and round with platform bashing? This adds nothing to the conversation other than pissing people off. So you like android! Well bully for you, I happen to think its its inferior in many ways, but I try to stick facts. So...

And who has thumbed through the manual.... The best advice I can give you at this point is read, and read again until you really understand, the manual. Ignore the section on doing a CSC to turn off the motors. Simply hold the left stick all the way down for 3 seconds after touch down and...

While DJI is often a difficult company to work with, there are plenty of examples on this forum of full replacement units being provided, not just discounts. Each situation is unique, and many crashes are not due to defect, but rather to pilot error. Sent from my iPad using PhantomPilots...

To each their own! I went from the iPad mini solution to the air 2, and prefer it greatly over the mini. I don't find it unwieldy and really like the additional screen real estate. Sent from my iPad using PhantomPilots mobile app

I've seen plenty of beautiful, cinematic shots from the Phantoms to know it can be done. I've also seen plenty of crap too, but there are so many Phantoms out there with noobs posting unedited, "this is my first video, isn't it great?" type stuff that it can be overwhelming. Hopefully you...

It may also be your shutter speed. Without a ND filter, you will often have shutter speeds so high that each frame is like a still photo, with no motion blur. This can make the video look unnatural and kind of choppy. Try some ND filters to try to get your shutter speed down to around 1/120 of...