Recent content by ICore

Update: I was able to solder the AVL58 Lite tx to the runcam3 and P2 successfully following @thelostsurfer information. https://phantompilots.com/threads/avl58-video-downlink-no-video.8665/#post-72805 To bad the WiFi module in the runcam3 camera is dead, I am unable to change camera settings...

So far, I was able to wire the following as described in the picture attached. I guess I do not need the FPV hub and cables because I do not have the gimbal and iosd mini device. The RX is already connected to the LCD tv but without power because the laptop charger I have outputs 19v and not...

The components I have are listed below. I am trying to get FPV to work with my P2 v2.0. I do not have a dedicated fpv monitor; therefore, I am using my SmartTv. I also do not have a dedicated battery and would prefer to connect the AVL58 RX to the wall 110v. I need a 110v to 12v convertor and I...

Sorry to hear that, if i were you and i thought it was bricked, i would keep resetting it until the flash is successful. Like i said, i am no expert, so I really just go the hard way when i think things are dead, this is what i did a few days ago with the main controller and on the 3rd try it...

Does anybody know if the H4-3D gimbal does panning also and not just tilting (up/down)?

Why not try a gimbal reset? There is videos on youtube for that. I am in no way an expert but i have been watching lots of youtube videos about drone gimbals lately lol.

The colors/sequence of the lights depends on the mode the MC is currently set no? My drone was doing the red,green,yellow but after a calibration it is now solid red, the compass is damaged and waiting for the new one to arrive. The motors turn and the P2 v2.0 is on NAZA-M mode.

You can do that on the Phantom 2 Assistant software no? I believe you will have to connect the drone to the computer each time you want to change settings.

The problem with my phantom 2 receiver 2.4ghz board is that the male connector got stuck to the female connector. When I tried to disconnect them from each other, i pulled "from the side of the cable", and the male connector was ripped from the board. I was not able to remove the male part off...

what do you mean?

Why? I am not here for trouble, but clearly his statement indicated bad sarcasm that i did not received as a real joke, specially when you do not know the poeple on the other end. After research through the forum and the web, i figured it was a firmware situation also. Thanks.

Compass error in P2 Assistant, getting a new compass soon.

After testing the tx communication with the drone, only 1 antenna is working, the other there is no connection to the rx board.

I believe I do not have the knowledge that you do about drones according to your signature, though coming strong about any subject that I have when I am only trying to learn more about it, is not the way to go in my opinion. I believe I have the right board already, and from what I know, all...

Thank you for caring about my finances. I do respect your concern on this matter, though politely I will tell you that is none of your business. Actually, BLHeliSuite is free and I can use it to flash firmwares with it on other systems, which I thought DJI was compatible. If i wanted to waste...