Recent content by icordoba

  1. I

    250mW vs 600mW

    Very glad to read that. That's the setup I chose (also got it at Banggood.com 9th June but I still haven't received it). Sometimes waiting is so hard...
  2. I

    My gimbal emits a strange sound.

    I have exactly the same problem but in my case the noise fades away when I start my Phantom and fly it. Any ideas?
  3. I

    250mW vs 600mW

    Hi, thanks for all replies. I agree with all your points QYV. My doubt on wether DVR or dual antenna was because of Boscam offering, either the single antenna with DVR or the RX LCD 5802, which is the one I finally chose. I also like it as has builtin rechargeable battery. (I though of the...
  4. I

    250mW vs 600mW

    I'm definitely going for a Monitor, not Googles at this point. I'm narrowing my search; I will probably choose between a Boscam combo or the Fatshark one: Boscam: 500mw transmitter: http://www.hobbyking.com/hobbyking/stor ... duct=22394 And either one of this screens...
  5. I

    250mW vs 600mW

    Thanks for both replies. It seems that for my needs I don't need 600/1W power but just good tx and rx antennas. I'll probably be installing: http://www.hobbyking.com/hobbyking/stor ... aff=773910 with http://www.hobbyking.com/hobbyking/stor ... aff=773910 About the las question still don't have...
  6. I

    250mW vs 600mW

    Hi, I plan to get a FTP system for my Phantom II. http://www.hobbyking.com/hobbyking/stor ... 00mw_.html I wonder what are, if any, the drawbacks of installing a 600mW transmitter vs. the lower power ones (200/250mW for example). What is the reason of installing these lower power system? Do...
  7. I

    Can't enable IOC modes (CL or HL). Naza enabled, of course.

    Re: Can't enable IOC modes (CL or HL). Naza enabled, of cour You put the pointer in CL position if you want to operate in Course Lock mode, HL for Home Lock mode. (Be sure to understand the difference between them). None of them will work if you haven't enabled IOC from the desktop app (which...
  8. I

    Won't get full satellite lock (just 6)

    Thanks both for your replies. I've also tested other GPSs in the same location and get more satellites recognised (and faster). I cannot understand how DJI does not solve this in a product where GPS reception is so critical. I'll test it in fully open space to be sure it's not an antenna...
  9. I

    Won't get full satellite lock (just 6)

    Hello, I'm having a problem when flying my Phantom 2. It hardly gets full satellite signal (more than 6 sats -> no red flashes). It stays a very long time with 2 red flashes (5 sats) then goes to one flash (6 satellites) and that's the best I can get. (Of course, with the corresponding green...
  10. I

    Can't enable IOC modes (CL or HL). Naza enabled, of course.

    Re: Can't enable IOC modes (CL or HL). Naza enabled, of cour Oh... mmm... well... mmm... what can I say... (of course I hadn't enable that... not even hadn't seen it). I know it's no excuse but docs I had downloaded just talk about enabling Naza mode. Thanks a lot... I wish I had registered...
  11. I

    Can't enable IOC modes (CL or HL). Naza enabled, of course.

    Hello, I'm a recent owner of a Phantom 2 and I'm having a problem when trying to activate both Home Lock and Course Lock (Switch S2). I hope I can get some help here. I've upgraded my Phantom to the last firmware, enabled Naza mode and done compass calibration (multiple times). Every thing works...