Recent content by Hvydg

I bought the main board used. It was suppose to be good but you know how that goes. I did notice the led in front was blinking red and the one in the rear is blinking green. I have another main board with the motor but it won't power on.

Well I actually fooled with the ribbon cable connection behind the camera itself. It helped a lot. Everything would work right except the camera. It would turn up then just fall down. I actually got a great deal on a phantom 3 professional on eBay. It had been crashed and the camera separated...

Forgot to mention. When it's all together and I'm on the vision app it says remove the gimbal lock but the gimbal lock is not on there.

Trying to get a camera going on my pv2+. I got this thing used. Installed a new ribbon cable and found out the main board up top was bad. Just got another board and now the LEDs blink red and there is a binding noise. I took it back apart and hooked up just the main gimbal board and motor. When...

What gimbal?

That's true. I have been a member for 15 years. Now if you are new they will hold the money until it is delivered. Just noticed there is another one on there now for $486 with another username and 0 feedback. Probably the same person. Auction is the same. Pisses me off! Lazy *** needs a job!!!

Well I figure if it's to good to be true it probably is. Lol. http://pages.ebay.com/link/?nav=item.view&alt=web&id=181812610781&globalID=EBAY-US

If the main gimbal board is bad will that cause it not to have telemetry also in the vision app?

Yes. All the cables are plugged up. I guess the wifi module is ok since I'm picking it up. I will not connect to the vision app. It will show a green light when you open the app but when you click on camera if says connection to phantom failed. I assume that's because the gimbal board of toast?

Hi everyone. Just got a used pv2+. The camera won't power on. (No led) when the bird is powered on and the extender is off I'm picking up a MAC address when I run Vistumbler. Does this mean the wifi module is ok? I'm guessing the main gimbal board is bad since the led is not on?Any help is...

Hi. Just got a vision 2 plus. It has 3.04 firmware. It flies great like it is. I know there has been several updates since then from What I have researched. Should I update to the newest 3.14 or leave it alone? Also is there any advantages to updating. Will It increase speed or possibly...

Well I tried everything else I could think of. Same issue. I ended up selling it and buying a vision 2 plus. Got a smokin deal on it. But I have to replace the ribbon cable on the camera. Any idea what kind of range I can expect with it stock?

Haha. I hear ya. I'm hard headed to! That's why I'm up at 12:10 fooling with it and have to be up at 6:00 For work in the morning. Lol.

I updated mine to 8.4 last night.

Wish mine would start. I'm about ready to sell it! Lol