My same problem exactly. Sent my Tx in because of a charging problem. On this one the maps worked, DJI sent a replacement but the maps did not work. Lots of firmware hocus pokus nothing worked.
I was sent a link to a file called "update.zip" which I was to run directly from the micoSD card...
I got a link from DJI support as well, downloaded the file put it on a micoSD and it got stuck at installing Go4 at the 10% level. The fix in the YouTube video did not work either.
I assume your transmitter has a HDMI out module and that is how you connect to the goggles using a cable. Note this is a digital signal. The NexwaveRF is an analog device and the two signals cannot be mixed even if they are on the same frequency.
Yes mainly because the camera is NOT mounted on a gimbal. Cranking up the gains in the NAZA flight controller also might steady the drone/video a bit better. This is an old self constructed drone kit from ~ 2014.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.