Re: H3-3D problem: motor noise, tilt/reset and possible fi
:-) Well, I feel a little silly. I usually fly with a few rubberbands holding it in so I can quickly get it out for other actvities.. The bracket did the trick. Hard to think that it works with H3, but not on the H3+.. Guess I...
Re: H3-3D problem: motor noise, tilt/reset and possible fi
Ok, has anyone else seen this? I just purchased a GoPro Hero 3+ Black edition, and when I put it on the DJI H3-3D, it goes crazy. As soon as I put back on my old Hero 3, all works as it should?
The Phantom is upgraded to latest...
Has anyone seen any strange behavior with their 3-D gimbal after upgrading to firmware 3.06? It was working fine before the upgrade and now after the upgrade it almost appears as if the motors are in a bind?
Has anyone seen any strange behavior with their 3-D gimbal after upgrading to firmware 3.06? It was working fine before the upgrade and now after the upgrade it almost appears as if the motors are in a bind?
And so I am planning a trip across the US. What should I be prepared to see as I travel to areas of greater declination? Increased wandering in forward flight? I will be sure to document my experiences and report back :?:
Ok, I am not sure if this fits here or not.. I haven't noticed mine hooking ( I live in south-eastern US), but have noticed on initial take off and forward flight that it drifts to the right as I am flying away - straight with no stick inputs. After a while it will correct itself and fly...
I like the arc concept if you can get it worked out, but each project may have a different arc radius making it difficult? As far as switching SB and SC. I typically get into one altitude and fly along to do my tracking and tilting, but each has his own filming methods. I also have moved from...
Sorry I haven't been on here in awhile so may have missed this. On the switch for the Gimbal auto tilt ( SB ) mine has about a 5 second delay from when I move the switch until the time the gimbal starts moving.
Does anyone else experience this, and is there a fix/adjustment?
Maybe it's my profile/TX, but does anyone else get a slight (noticeable) delay on the gimbal tilt when using the SB toggle?
Maybe I need to run the X1 calibration again?
Curious if anyone here has updated the Phantom to the latest FW that was just released? I have heard/read of issues with it over on RCGroups... :shock:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.