get this: http://www.goodluckbuy.com/dji-phantom- ... raphy.html
I have the one before this and it kick butt. This one looks really slick and it more than likely comes with AlexMos 2.2b install and built
http://www.goodluckbuy.com/dji-phantom- ... raphy.html
Also quite interesting IMO Walkera QR X350 GPS Phantom GoPro
http://www.rcgroups.com/forums/showthread.php?t=1976965
for ~400usd w/ transmitter
http://www.goodluckbuy.com/walkera-qr-x ... rival.html
or
for 100usd less than the phantom get full fvp... that is a deal...
u need this:
TL-242 Thread Locker & Sealant Medium Strength
Easy removal, used for Fixing and sealing of threaded fastener
http://www.hobbyking.com/hobbyking/stor ... ngth_.html
@telemole,
I do a lot of filming at or near the ocean which is not very forgiving. I had done > 100 flights over the ocean and for some reason, this shoot got me...well, actually one of the dji batts went out after 4 minutes. I raced to get it into the shore, and came withing 10 feet of being...
This is a really clever way of reversing the position of this (http://www.goodluckbuy.com/dji-phantom- ... raphy.html) gimbal to allow for clearance of the goprowater proof case. I just got the one I am using installed on the craft (a dji phantom) but I really dont like the fact that it is...
which goodluckbuy gimbal? it prolly already comes with firmware setup and all you have to do is power it. If you managed to fash it (not recommended if it has preloaded firmware) then you are going to have to reset the PID values, which I had to do with that rctimer gimbal way back. This is kind...
interesting and helpful write up on this gimbal for the fellow who needs help (and others interested)
Hope you enjoy.
http://garagepilots.com/forum/topics/go ... e=activity
so what happens when you plug a 4S battery in? It prolly will just work if you didnt erase anything. Sounds to me like you didnt do anything to it. I dont believe that these gimbals function very well unless you give them a pretty strong current, like what I am using --a simple Zippy compact 4C...
@btconverse, so what did you use to flash it? Martinez using Arduino? I had the same thing in mind as it comes with no instructions only I plugged in a battery in and it worked...which was cool for me.
I am *guessing* that they are using http://code.google.com/p/brushless-gimb ... loads/list...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.