Recent content by hobsonmedia

I have a P2, GP3+, Z H3-3D, 7" FPV Monitor. iosd. Tired of lugging around the monitor and fighting the balance issues with it mounted on the remote. Question - Is there a way for my iPhone 6 to serve as the FPV monitor, given my existing setup? (see pic) Would be a great reduction of mass and...

It's truly and fully powering down. The green led changes to red on the monitor and I have to power it back up.

No, just FPV

Will certainly check both those things. It would be much less perplexing if it had never worked...but it worked great up until a couple days ago when I was shooting indoors at a church.

The behavior doesn't change. As long as the tx turns on, the monitor shuts down.

When I power it back up, it flickers once and goes back off. Battery is full, and monitor works (showing snow) for hours uninterrupted until the TX is activated.

Sorry for the confusion. I tried to post a video from my iPhone, but this forum doesn't allow that. I'll take a pic of the setup on my P2... Let's see if this helps convey the problem more completely: I have a P2, with the TX and iosd mini mounted on the bottom. This config has worked well for...

Here's a fun one I'm sure those with more FPV experience can help remedy... My monitor stays on and shows a great picture until the P2 is on. In other words, I enjoy some of the best snow you could want. But when I power up, off she goes. Why?

Voila! Fixed it. Some idiot reversed the controls. No telling who did that. Thx for the offer to help :)

There's not much to post...at full throttle it doesn't move an inch off the ground. It's like there's something inhibiting the power. Thought it might be a bad battery (had a brand new one on), so I swapped it out...made no difference. Something is clearly changing the delivery of thrust. What...

In keeping with Murphy's Law, I just took it outside to try the new settings. The gimbal/scroll wheel works great...but the P2 won't lift off the ground at all. Rotors spin at what sounds like half speed. I checked everything in the gain settings, and they're at default levels. It's about 25...

Probably the simplest thing you suggested-resetting the cable. After I did that, the gimbal was recognized, updated, and then working properly. I never would have found that solution without your help, so thank you once again!

Success! Thank you SO much for the patient answers to my numerous questions. Have a wonderful Christmas!

I don't appear to have any cable on the back of the gimbal. Does this look right to you or am I missing something important?

Will give that a shot tomorrow. Thanks for the advice!