Ahhh huh?
That video was shot at 2.7k in protune RAW on Wide. That shouldn't matter though.
It doesn't matter what I set the gopro too, I can still physically see, with my own eyes, the gimbal vibrating.
Hey Buddy,
Thanks for the suggestions.
I finally was able to try this, interesting experiment to go through.
Unfortunately it didn't resolve my problem. The proper I had on there were all in the range or 1.9 to 2.1 exactly over a minute test each.
I did try some older ones that gave me results...
I'm having issues with my set up and I cannot seem to resolve them.
See here: https://vimeo.com/102629842 Pass: wobble
As you can see in the video the video there's a lot of wobble, especially when the drone is standing still.
It's intermittent, it doesn't happen the entire flight, but it...
Thanks for the notes.
Funny you should mention it because before I cut a hole in the belly; the first thing I did was buy longer screws, washers and locking nuts. I used these to drop the gimbal down about 5mm and that gave the yaw motor clearance. This was terrible however. The entire gimbal...
I have the older version of the Phantom 2; without the cutout in the bottom to give the 3D clearance.
Instead of paying $30 for the adapter part, I just cut a clean hole where the top the gimbal needs clearance.
The 3D now does not rub on the bottom of the drone; however it now shakes like...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.