Recent content by hellion

Just wanted to know if i could replace my p3s main board with a p3 4k board.

The yaw arm and roll arm are both good. Sent from my SM-T217S using PhantomPilots mobile app

I did crash it and replaced the yaw arm, flex cable (only because it came with the yaw arm) and replaced the body because of a bend on motor #3. The camera would still face forward after the crash and a gimbal calibration. It was tweak but forward till after my repair. I was able to align the...

Thank you for replying dan, i did cover all that. Did the IMU while it was cooled down. rebuilt the gimbal again and still off by a bit.

No problem, no range extender i have flown my p3s just short of two miles. Wide open space and no device attached to my controller blocking the internal antenna.

The range extender? Haven't found a need for it yet.

Unfortunately the kit does not come with a compass or GPS pad, but easy fix either way. Sent from my SM-T217S using PhantomPilots mobile app

Rebuilt my Phantom 3 standard from the ground up rebuilt the camera gimbal did Hardware alignments on the gimbal for the life of me can't figure out why my camera points slightly to the left what am I missing never seen this problem Sent from my SM-T217S using PhantomPilots mobile app

I did a full gimbal repair Flex cable realign my horizontal on my camera everything works great except it points a little bit to the left what am I missing I can't find in tutorials